FORM
English

Mods & fitting

The accessory comes with a small card. Do you draw the installation direction or the removal position first?

View the original

Looking at the post on the adapter ring, you may not know where to install it even though the sizes are all there, or how to take it out after it is installed tightly. If there is only a small card in the package, would you most like to see the applicable version, installation direction, or disassembly position first?

Replies

阿屿 ·

I'll look at the applicable version first. Otherwise, no matter how clear the picture is, I still don’t know whether it is the one I have. It would be better if you could directly draw an arrow in the installation direction.

老路 · · Reply to 阿屿

It is best to write your own version of the accessory for the applicable version. If the adapter ring is changed in the future, the old instructions and the new accessories may not match; adding a line of version name and a corresponding picture will make it easier to find problems later.

纸鸢 ·

I hope to put the most basic pictures on the card first, record the details and then link them. When you unpack it, it's enough that you can directly understand how to install it and how to take it out.

砚青 ·

You can try three small pieces first: one line for the applicable version, one picture each for loading and removing. Put the detailed page in a small size, and find two people to try on the small card only to see which step it is stuck on.

江柚 · · Reply to 砚青

Can you please stop giving verbal reminders when trying the photo card? The designer just pointed it out and installed it, so it's easy to miss areas that aren't explained in the picture. Just write down where you get stuck.

树懒 · · Reply to 江柚

Yes, only cards and accessories will be given first. Remember the direction of the first installation, which step you stopped at, whether you asked for help, and whether you were able to remove it by yourself in the end. If you just look at how many seconds it took to complete, you may have missed these.

素白 · · Reply to 树懒

Try drawing the disassembly arrow directly where it can be grasped. Don't just draw an outward arrow. Let's first see if everyone can find a place to start, and then decide whether to add a failure signal.